Spektrum SPM18000 DX18QQ User Manual download pdf (Page 62)

SPEKTRUM DX18QQ

Adjusting the Elevator Centering Screw

When changing between Modes 1 and 2, or between Modes 3 and 4, you must

adjust the elevator centering screw.

1. Hold the Elevator or Throttle stick

in the full up or full down position

when you are adjusting the elevator

centering screw. Holding the gimbal

stick reduces the load on the elevator

centering mechanism and makes it

easier to adjust the centering screw.

2. Locate the gimbal where the elevator

centering spring is engaged. Use a

Phillips screwdriver to tighten the

elevator centering screw. Tightening

the screw will disengage the center-

ing spring.

3. Using a Phillips screwdriver, loosen the opposite elevator centering screw until

the lever engages.

Re-assembling the Transmitter

1. Put the back of the transmitter case on the main case, taking care to not

pinch any wires or the rubber grips.

2. Install and tighten the four Phillips screws.

3. Install the top of the rubber grips on the transmitter.

Moving the Throttle Limiting Wedges

Throttle limiting wedges are used to limit the maximum throttle travel. When

changing between Modes 1 and 2, or between Modes 3 and 4, you must move

the throttle limit wedges.

1. Use a Phillips screwdriver to remove

the throttle limiting wedges from the

current positions.

2. Install the throttle limit wedges on the

opposite gimbal.

Adjust Stick Tension

Adjust stick tension using the screws on the stick gimbals through holes in the

back of the transmitter.

1. Remove rubber plugs from holes marked with a vertical arrow or a horizontal

arrow.

2. Turn the screws in these holes a small amount using a small Phillips screw-

driver to adjust tension on the vertical and horizontal gimbals.

NOTICE: Always do a test of stick tension while turning these screws to ensure

stick tension is not too loose or too tight. Tightening a screw too much can dam-

age a spring. Loosening a screw too much can let a spring fall off and cause

short-circuit in the transmitter.

CAUTION: Always power off the transmitter, disconnect and remove the

battery before adjusting stick tension or friction straps. Not doing so could

result in property damage or injury.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Comments to this Manuals

No comments

Spektrum SPM18000 DX18QQ User Manual Page 62

Comments to this Manuals

Related products and manuals for Control panel Spektrum SPM18000 DX18QQ