Spektrum SPM6700 Instruction Manual download pdf (Page 31)

31SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL

FUNCTION LIST



Back Mixing

BackMixingappliesamixtoallrelatedservosinawingortail

type.Forexample,ifyouselect2AIL,2FLAPintheAircraftType

screen,amixtooneaileronchannelaffectsbothaileronservos.

Themixresponse,however,dependsontheaileronchannel

includedinthemix.

ABackMixalsoenablesyoutousefewermixestoachievethe

desiredresponse,forexampleaddingrolltoasplitelevator.

Range Test

The Range Test function reduces the power output. This allows for

a range test to conﬁrm the RF link is operating correctly. Perform

a range check at the beginning of each ﬂying session to conﬁrm

system operation.

To Access the Range Test screen:

1. With the transmitter on and the main or telemetry screen

displayed, press the scroll wheel. The Function list displays.

2. Scroll to highlight Range Test, then press the scroll wheel to

access the Range Test function.

3. With the Range Test screen displayed, push and hold the

trainer button. The screen displays Reduced Power. In this

mode the RF output is reduced allowing for an operational

range test of your system.

4. If you let go of the trainer button, the transmitter will go back

to Full Power.

IMPORTANT: Telemetry alarms are disabled during the

Range Test.

Range Testing the DX6

1. With the model restrained on the ground, stand 30 paces

(approx.90feet/28meters)awayfromthemodel.

2. Face the model with the transmitter in your normal ﬂying

position and place the transmitter into Range Test mode (see

above). Then push the trainer button; the power output will be

reduced.

3.Operatethecontrols.Youshouldhavetotalcontrolofyour

model with the transmitter in Range Test mode.

4. If control issues occur, contact the appropriate Horizon Product

Support ofﬁce for assistance.

5. If performing a range test while a telemetry module is active,

the display will show ﬂight log data.

Timer

The DX6 Timer function allows you to program a countdown timer

or stop watch (count up timer) to display on the main screen. An

alarm sounds when the programmed time is reached. You can

program the timer to start using the assigned switch position

or automatically when throttle is raised above a programmed

position. Two internal timers are available that show run time for a

speciﬁc model displays on the Main Screen. A total system timer

is also available.

Timer Event and Timer Control Alerts

Press NEXT to select the Timer Event Alerts settings. These

include options for the alerts at every minute for down timers, 1

minute remaining alert, 30 seconds remaining alert, 10 second

to1secondreminingalerts,expirationalert,andeveryminuteup

alert. Press NEXT again to select the Timer Control Alerts settings.

Available options include Timer Start alert, Timer Stop alert, and

Timer Reset alert.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Comments to this Manuals

No comments

Spektrum SPM6700 Instruction Manual Page 31

Comments to this Manuals

Related products and manuals for Toy parts Spektrum SPM6700