Spektrum SPM6700 Instruction Manual download pdf (Page 29)

29SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL

FUNCTION LIST



D/R & Exponential

DualRatesandExponentialareavailableontheaileron,elevator

and rudder channels.

To adjust the Dual Rate and Exponential:

1. Scroll to the channel and press the scroll wheel once. Scroll

left or right to select the channel you wish to change and

press the scroll wheel again to save the selection.

2. Scroll to dual rate and press the scroll wheel. Scroll left or

right to change the value and press the scroll wheel again to

save the selection.

Exponentialaffectscontrolresponsesensitivityaroundcenterbut

hasnoaffectonoveralltravel.Positiveexponentialdecreasesthe

sensitivity around the center of gimbal movement.

Differential (ACRO and SAIL Types only)

The Differential screen enables you to increase or decrease the

amount of differential between aileron control surface throws.

Positive Differential values decrease the amount of “down” travel

without affecting the “up” travel on the opposite control surface.

Negative Differential values decrease the amount of “up” travel

without affecting the amount of “down” travel on the opposite

control surface.

The Differential menu option only appears when a multi-servo

aileron wing type is active in Aircraft Type.

To adjust the Differential:

1. Scroll to Switch and press the scroll wheel. Scroll right to

selectOn(Differentialisalwayson)orassignthedifferentialto

a switch position.

2. Press the scroll wheel a second time to save the selection.

3. Scroll to the percentage selection and press the scroll wheel

once to change the value.

4. Press the scroll wheel again to save the selection.

Throttle Cut (ACRO and HELI Types only)

The Throttle Cut menu option enables you to assign a switch

position to stop an engine or motor. Throttle Cut activates

regardless of Flight Mode.

When you activate Throttle Cut, the throttle channel moves to the

pre-programmedposition(normallyOff).

You may need to use a negative value to move the Throttle

channel to the off position.

CAUTION:

Always test the model after making

adjustments to make sure the model responds to controls

as desired.

Throttle Curve (ACRO and HELI Types only)

You can use the Throttle Curve menu option to optimize the

throttleresponse.Amaximumof7pointsareavailableonthe

throttle curve.

To add points to a Throttle Curve:

1. Move the throttle stick to the position where you wish to add

the new point.

2. Scroll to Add Pt. and press the scroll wheel to add the point.

To remove points from a Throttle Curve:

1. Move the Throttle stick until the cursor is near the point you

wish to remove.

2. Scroll to Remove Pt. and press the scroll wheel once to

remove the point.

If you program multiple throttle curves and you wish to edit one of

the curves, that curve must be active in the Throttle Curve screen

before you can make any changes.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Comments to this Manuals

No comments

Spektrum SPM6700 Instruction Manual Page 29

Comments to this Manuals

Related products and manuals for Toy parts Spektrum SPM6700