Note: If desired, the antenna can be shortened (cut) to exactly 3.6" with negligible loss of range and in some applications the short 3.6" l
Receiver Channel UsagePort 1 – Battery and telemetry optionsPort 2 – CH1 SteeringPort 3 – CH2 Throttle Port 4 – CH3 Auxiliary channel or personal tran
It’s necessary to program the receiver to a specific module so that the receiver will only recognize that module, ignoring signals from any other sourc
5. With the transmitter off, place the transmitter sticks and auxiliary channels in their desired fail-safe positions, normally brake and straight ahe
In the unlikely event that the link is lost during use, the receiver will drive the servos to their fail-safe positions that were preset during the b
Specification Range UnitsFrequency Band 2.400–2.4835 GHzChannels 79Channel Spacing 1 MHzChips/Bits 64DSSS Coding Gain 18 dBBitrate 15.625 k
Specification Range UnitsOutput Power 10 mWAntenna 2 dBiModulation Digital GFSK 160kHz dFSensitivity -98 dBm BER 1E-3RC Channels 3Power 40
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful inter
Spektrum 1-Year WarrantyThis Spektrum™ product is guaranteed against workmanship and manufacturing defects for a period of 1 year from the original da
Include your complete name and address information inside the carton and clearly write it on the outer label/return address area. Include a brief summ
Alternate Languages ...3Introduction ...
ITALIAN: Per la versione italiana di questo manuale vi preghiamo di visitare il sito www.spektrumrc.comFRENCH: Pour consulter ce manuel en françai
Spektrum’s Digital Spectrum Modulation (DSM) system offers the ultimate in radio link security. No longer do you have to worry about transmitters on y
• Eliminates the possibility of interference from an unintentional turn-on• Impervious to model-generated RF interference (like noisy motors, speed co
The DSM system operates in the 2.4GHz band (that’s 2400MHz). This high frequency offers a significant advantage as it’s well out of the range of model-
During first installation, the receiver(s) must be bound to the transmitter module. Binding is necessary to program the receiver(s) to distinguish its
5. If the transmitter is PPM and PCM compatible, make sure the transmitter is programmed to PPM modulation mode. If necessary, see the instructions in
1. Using double-sided foam tape, mount the receiver in the position recommended in your vehicle’s instructions.2. At 8.5 inches in length, the receive
Comments to this Manuals